Advertisement
assemblY/mounting
instructions
read entire important saFetY
inFormation section at beginning of
this document including all text under
subheadings therein before set up or use.
1.
The Mini Tire-Changer can be mounted
temporarily in a vise (not included) or
permanently to a secure workbench or surface.
2.
For permanent mounting, use pencil to mark
installation holes. Use mounting hardware
(not included) to mount the Base onto a secure
workbench or stand, making sure that there are
no hidden cables or wiring below installation
surface.
3.
Verify that all hardware (uses 7/16" or 1/2" bolts,
flat and lock washers and hex nuts) are secure
and that base is mounted evenly and is level.
4.
Insert Holder (16) into Base and lock together
using the Base Pin (13). See Figure 1.
Base (15)
Base Pin (13)
5.
For temporary mounting to a vise, position the
Base between vise jaws with the Base Pin
accessible from the sides of the vise. Tighten
vise jaws, Use vice jaw guards to prevent
damage to Holder surfaces. See Figure 2.
Hub Holder (16)
Vise
remoVing tire operation
1.
Remove balancing weights, if any, from rim
edges.
Page 2
Holder (16)
Figure 1
Figure 2
For technical questions, please call 1-800-444-3353.
2.
Remove tire valve core to deplete the tire.
3.
Place tire rim over Threaded Shaft (18). See
Figure 3.
Figure 3
Tire Assembly
Hub Holder (16)
4.
Install cone end of the Alignment Disc (1) over
the Threaded Shaft (18).
5.
Place both Spacers (2) over the shaft.
6.
Thread the Locking Nut (3) over the Threaded
Shaft (18) and tighten.
7.
Attach the end of the Forcing Handle (5) to the
tab of the Locking Nut (3) using one of the Pins
(6).
8.
Insert Breaker Handle (4) through the slot in
Forcing Handle and attach the rubberized Grip
(12) to the Breaker Handle, making sure that
the finger grip end of the handle is towards the
Locking Nut.
9.
To break tire beads, Breaker Handle foot should
rest horizontally over the tire at edge of rim. (Use
combination of adjustment holes in the Forcing
Handle and Breaker Handle and if required,
remove one of the Spacers). See Figure 4.
Grip (12)
Breaker
Handle (4)
Forcing Handle (5)
Locking Nut (3)
Spacer (2)
Alignment Disc (1)
Threaded Shaft (18)
Base (15)
Pin (6)
Figure 4
SKU 34552
Advertisement
