DEXAPLAN DV 622 - MANUAL 1 DU 18-10-2007 Manual

! Use a slightly moist cloth, using a little detergent if necessary, for
cover, wear and tear or damage to fragile parts. The product is intended
cleaning the surfaces. Do not use any chemicals. solely for private use and not for commercial use. In the event of incorrect
and / or improper handling, the use of force or any unauthorised repair to
the device, the warranty will become invalid. This warranty does not affect
Disposal
your statutory rights.
Do not dispose of packaging material, used batteries or products as
household waste. Please use your recycling system. Details are
Service
available from your local authority.
Information on dealing with common problems can be found at
www.dexaplan.com. If you have any questions, please contact our service
Warranty
office by email (service@dexaplan.de) or by telephone
This device is warrantied against defects for 3 years from the date of
( 0870 - 241 3029 Mo.-Fr. 8.30 - 17.00;
GB
purchase. Please keep your receipt as proof of purchase. If you have a
851 Mo.-Fr. 8.30 - 17.00). Here you can obtain all necessary information
claim under the warranty, please contact the service office for your country.
on service questions such as returns, etc.
This is the only way to ensure that your device can be sent free of charge.
This warranty is only valid for the first purchaser and is not transferable.
The warranty covers material or manufacturing defects only and does not
Troubleshooting
Fault Cause Remedy
Only interference can be seen The cable connection between event recorder and TV is Check all connections
on the screen not correct
The wrong channel on the TV has been selected Set the TV or the monitor to the correct AV channel
The event recorder is switched off. Switch on the event recorder
A blue screen is displayed or You have selected the wrong video input on the video Press the "Monitor" button repeatedly until the desired
the image appears as a recorder image is displayed
picture in picture The camera is not connected correctly Check the camera connection
Interferences in the image / There is too little light available for illumination Illuminate the surveyed area with more light
image too dark
Overexposure of the image Strong backlighting is directed at the camera lens Change the alignment of the camera or change the location
(completely light image)
Colours appear unnatural, The CMOS camera sensor is calibrated for daylight Adjustment is not possible
particularly in artificial
lighting
Too many stored images The software reacts to changes in the image-these can Do not point the camera at areas with changing light
without detectable changes also be changes in the light conditions conditions
The storage mode cannot be The storage mode cannot be switched off during a Wait until no more image changes are detected and then
deactivated recording; if image changes are detected, recording is switch off the storage mode
made automatically
Images have not been stored If an image area changes constantly, only the first You cannot change this setting; this is designed to minimise
although movement was change will be recorded the number of recorded images for the same event
present The contrast in the image was not sufficient during the Install the camera nearer to the surveillance area and/or
movement install additional lighting
The wrong channel has been selected for recording. Select the correct channel for recording.
Channel 1 is automatically selected for recording after Select channel 1 for the recording in the event of power
a power failure failure
There is no data on the SD The SD memory card has not been inserted properly or Insert the SD memory card in the memory card slot and
memory card the recording mode has not been activated check all settings
Date and time have changed The power supply has been disconnected for longer Set the date and time again
than 12 hours
GB / IE - 10
SECURITY CAMERA
WITH DIGITAL STORAGE DEVICE
SURVEILLANCE CAMERA WITH DIGITAL EVENT-RECORDER
1890 851
IE
Dexaplan GmbH
Paul-Böhringer-Str. 3, D - 74229 Oedheim
18/10/2007
Ident.-Nr.: 18-10-2007-DV 622-GB-L116
GB
DV 622
IE Operating and safety instructions
Contents
Introduction ........................................................................Page 2
Proper use .......................................................................... Page 2
Package contents ................................................................ Page 2
Equipment .......................................................................... Page 4
Technical data ..................................................................... Page 4
Safety instructions ............................................................... Page 4
Location of the event recorder ............................................... Page 5
Location of the camera . ....................................................... Page 5
Connection ......................................................................... Page 5
Mounting the camera .......................................................... Page 5
Operation ........................................................................... Page 6
Function modes of the event recorder .................................... Page 6
Introduction
Read through these operating instructions completely and carefully and
while doing so fold out page 3 with the illustrations. The operating
instructions are an integral part of the product and contain important
information about operation and handling. Always observe all the safety
instructions. Check whether all parts are correctly installed before
operation. If you have any questions or are unsure about using the
equipment, please ask a specialist, obtain information on the Internet
at www.dexaplan.com or contact the service office. Keep these
instructions in a safe place and pass them on to third parties if
applicable.
Proper use
The Set DV 622 is used for the automatic digital recording of still
images or short video sequences.
It consists of a C-80 camera and a DVS 100 digital event recorder
connected using a plug in cable and a DSA-5P-05 FEU or DSA-5P-05
FUK power supply. The camera is weatherproof (protection class IP44)
and is thus suitable for both the surveillance of indoor areas and also for
installation and surveillance outdoors. If the recording function is
switched on, changes and movements in the camera image will be
detected by the internal software and a still image or a video sequence
will be saved on an SD memory card together with date and time. An SD
memory card with maximum 2 GB capacity can be used.
Manual recording of still images or video sequences is possible by
pressing a button.
Live images can be viewed by connecting the event recorder to a
television or video monitor. Alternatively, stored images can be read
from the SD memory card on a PC.
The set DV 622 is designed for operation in private households. It is
L116
Live image mode ................................................................. Page 6
Setting mode ...................................................................... Page 7
Recording mode .................................................................. Page 7
Playback mode . .................................................................. Page 8
Deleting of stored still images / video sequences ................... .Page 9
Manual recording (Quick Shot) ............................................. Page 9
Optional accessories ............................................................ Page 9
Maintenance + cleaning .................................................... Page 9
Disposal ............................................................................. Page 10
Warranty ............................................................................ Page 10
Service ............................................................................... Page 10
Troubleshooting .................................................................. Page 10
designed for automatic recording of events and is not suitable for
continuous recording. The unit is not a substitute for a professional
video surveillance system. Any other use or modification of the device is
not authorised. No liability will be accepted for consequential damages
or for damages caused by improper use or incorrect operation. No
liability will be accepted for consequential damages caused by any
function or by malfunction. Unless any liability is specifically required
by law, claims for damages, in particular those for personal injury or
property damage caused by non-functioning or malfunctioning of the
machine, are excluded.
A video surveillance system does not replace your duty of care or
supervision.
Observe the regulations concerning video surveillance in commercial
and public areas.
An additional camera with connection cable is available as an
accessory. This camera is used for extended live surveillance. Only still
images or short video sequences from one camera can be recorded. If
two cameras are connected, the camera input for recording must be
selected manually.
Package contents
Check the package contents are complete and that the equipment is
undamaged immediately after unpacking.
1 camera with bracket and 1 m cable
2 screws and 2 wall plugs
1 connection cable, approx. 14 m
1 event recorder
1 low voltage distribution cable
1 power supply
GB / IE - 2