Download Print this page

Advertisement

Hayward D.E. Filter
Basic safety precautions should always be followed, including the following: Failure to follow instructions
can cause severe injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for
one of the following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property
damage and if ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard. It can also make consumers aware of actions that are
unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
Owner's Manual
IMPORTANT SAFETY INSTRUCTIONS
Hayward Pool Products
620 Division Street, Elizabeth, NJ 07207
Phone: (908) 355-7995
www.hayward.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Contents
Product Warnings......................2
Introduction...............................4
Installation.................................4
Starting Pump and Filter............5
Filter Control Valve.....................6
Winterizing..................................9
Replacement Parts....................10
Warranty.....................................11
Registration................................12
ISDE2423 Rev D
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the DEP60 and is the answer not in the manual?

Questions and answers

Summarization of Contents

GENERAL INFORMATION
Required Clearance Specifications
Details necessary installation clearances for filter models.
INSTALLATION
Installation Steps
Step-by-step guide for installing the filter system and its components.
STARTING THE PUMP AND FILTER SYSTEM
Before Starting the Pump
Pre-start checks and setup for the pump and filter system.
Starting Pump
Steps for safely starting the system pump.
Pre-Coating
Process of applying D.E. for initial filter coating.
Operation: Filtering
Describes the normal filtering operation and when to backwash.
FILTER CONTROL VALVE FUNCTIONS
Six-Position Vari-Flo Valve Functions
Details functions for Vari-Flo valve models: FILTER, BACKWASH, RINSE, WASTE, RECIRCULATE, CLOSED.
Four Position Selecta-Flo Valve Functions
Details functions for Selecta-Flo valve models: FILTER, WASTE, BACKWASH, POOL OR SPA BOOST.
Two-Position Slide Valve Functions
Details functions for Slide valve models: FILTER, BACKWASH.
Manual Cleaning
Instructions for manual cleaning, including backwashing.
Filter Disassembly Instructions
Step-by-step guide for disassembling the filter system.
FILTER RE-ASSEMBLY INSTRUCTIONS
Clean Seal Ring and Seal Surface
Procedure for cleaning the seal surfaces on the filter body.
Re-installing Element Cluster
Steps for correctly reinstalling the filter element cluster.
BODY AND CLAMP RE-ASSEMBLY
Body and Clamp Re-assembly Steps
Detailed steps for reassembling the filter body and securing it with the clamp.
Vacuuming
Instructions on how to perform vacuuming with the filter system.
Save PDF