Page 1
OPERATION AND INSTALLATION MANUAL European Standard Certification UNE EN-13229 inserts European Standard Certification UNE EN-13240 stoves LISEO s.r.o. Folknářská 1246/21 Děčín 2 – Nové Město 405 02...
OPERATION AND INSTALLATION MANUAL INTRODUCTION GUARANTEE CONDITIONS 1.1. SAFETY WARNINGS …………………………………………………………………………………..3 1.2. GUARANTEE CONDITIONS…………………………………………………………………………..3 INSTALLATION IN ACCORDANCE WITH LOCAL AND NATIONAL STANDARDS 2.1. OPERATING AREA …………………………………………………………………………………….4 2.2. PRECAUTIONS …………………………………………………………………………………………4 2.3. CONNECTION TO THE EXTERNAL AIR INTAKE………………………………………………….4 2.4. CONNECTION TO THE FLUE PIPE………………………………………………………………….5 2.5.
Pay special attention to the laws and regulations in the area of the device installation. LISEO doesn't take any responsibility in the event of failure to comply with these precautions. To ensure its proper operation, the stove components can only be replaced by original spare parts and repaired by an authorized Assistance Technical Center.
OPERATION AND INSTALLATION MANUAL INSTALLATION IN ACCORDANCE WITH LOCAL AND NATIONAL STANDARDS 2.1. OPERATING AREA Ventilation: To allow proper operation, verify that the oxygen required for combustion can be obtained in sufficient quantity in the place where it is to install the appliance. Location of appliance: Choose a central location in the room that favors a good distribution.
OPERATION AND INSTALLATION MANUAL 2.4. CONNECTION TO THE EXTERNAL AIR INTAKE The smoke exhaust system must be unique to the insert (Not allowed pipe discharges common to other fireplace). Fumes discharged is made from the opening situated at the top. The discharge pipe must be connected to the outside using appropriate tubes and eventual isolation.
OPERATION AND INSTALLATION MANUAL CONTROL OF APPLIANCES 1º air combustion 2º air combustion optional in some models Valid for models of the L7 / K7 range Version 01.2017...
Page 7
OPERATION AND INSTALLATION MANUAL Clean glass 2º Air combustion 1º Air combustion Premium Canaria Version 01.2017...
Page 8
OPERATION AND INSTALLATION MANUAL Clean glass 1º Air combustion L71 Black Version 01.2017...
OPERATION AND INSTALLATION MANUAL DIMENSIONS AND TECHNICAL SPECIFICATIONS GENERAL INFORMATION All our units are made of gray cast iron FG20. All technical details and dimensions of the appliance are given in the data sheet attached to this manual. INSTALLATION AND ASSEMBLY IMPORTANT The chimney can only be installed and connected to the flue by a specialized technician, respecting in every time the national and local standards and in compliance with UNI 10683.
OPERATION AND INSTALLATION MANUAL 6.2. CHOICE OF FUEL Use only wood with suitable characteristics. Without moisture. Get advice from your installer about the most appropriate wood for burning existing in your region. Heat capacity of the timber in relation to the contained moisture. Heat power Wood drying time (i.e.
OPERATION AND INSTALLATION MANUAL 6.5. EMERGENCY SITUATIONS If, for any reason, you have to quickly extinguish the fire of the fireplace or intervene in a fire trapped in the flue pipe, act following the proposals below: Always leave the appliance door closed, ...
OPERATION AND INSTALLATION MANUAL 7.3. CLEANING THE INTERIOR WALLS (refractory) With the cold chimney, brush the soot that may be adhered. 7.4. DISASSEMBLY AND CLEANING THE CAST IRON DEFLECTOR See technical sheet attached for your appliance 7.5. CLEANING OF PAINTED PARTS Do not use abrasive or aggressive products or materials.
Need help?
Do you have a question about the L9 series and is the answer not in the manual?
Questions and answers