ZENEC ZE-NC520 - NAVIGATION Software Manual page 15

The following area appears next to the above described rounded area. When tapping this area, the
result depends on the information currently shown.
Icon Information
There is no valid GPS
position
Traffic restriction
Second route event
(manoeuvre after the
,
next manoeuvre)
Stops the running
simulation
Route recalculation
progress
Indicator strip
The following symbols appear in the Indicator strip:
Icon
The sound output of ZENEC Navigation Software is muted.
The sound output of ZENEC Navigation Software is enabled.
No TMC receiver is connected or TMC is turned off.
Details
If there is no valid GPS position, this symbol
appears here.
When GPS position is available but there is no
route to be navigated, the traffic restriction of the
upcoming intersection is shown here if there is
any.
When GPS position and an active route are both
available, this field shows the route event that
follows the next route event shown in the above
described area.
This icon appears during Route Simulation.
During route recalculation, this field shows the
recalculation progress between 0% and 100%.
- sounds muted/enabled
- TMC status
Description
Action
Tap this
area to
open the
GPS Data
screen to
check the
signal
status or
the
connection
settings.
Nothing
happens if
you tap this
area of the
screen.
Tap this
area to
open the
Itinerary
screen with
the turn by
turn
guidance
instructions
.
Tap this
area to
stop the
simulation.
Nothing
happens if
you tap this
area of the
screen.
Nothing
happens if
you tap this
area of the
screen.
15