The Controls And Displays On The Well Tens - IBP WELL TENS Instructions For Use Manual

8. The controls and displays on the Well TENS

Item Control
On/off knob, pulse
1
strength control
Display
2
3
(µs)
PULSE WIDTH
4
(Hz)
PULSE Rate
MODE
5
TIMER (Min)
6
32
Function
Use the left knob to switch Channel 1 of the Well TENS on
and off.
Use the right knob to switch Channel 2 of the Well TENS on
and off.
You can increase and decrease the strength of the pulses
(0 – 80mA) for Channel 1 and Channel 2 independently
of one another by rotating the appropriate knob clockwise or
anticlockwise.
The LED display on the left lights up when you switch on
Channel 1. The LED display on the right lights up when you
switch on Channel 2.
■ Operating mode B: the LED displays flash steadily.
■ Operating modes C and M: the higher the setting of the
pulse rate, the quicker the LED displays flash.
Once the pulse rate reaches approx. 10 Hz the LED displays
remain lit constantly.
By turning this dial you can set the pulse width to any level
between 30 μs and 260 μs.
The setting applies to both channels.
By turning this dial you can set the pulse rate to any level
between 2 Hz and 150 Hz.
The setting applies to both channels.
Use this button to select the mode for your treatment.You can
choose between three modes: continuous mode (C), cyclical
mode (B) or modulated mode (M)
Use this sliding switch to set the length of the treatment.
You can choose between three settings:
■ C: unlimited duration of treatment
■ 30: 30-minute treatment
■ 60: 60-minute treatment
The setting applies to both channels.