ESET MAIL SECURITY 4 - V4.2 FOR MICROSOFT EXCHANGE SERVER Installation Manual page 42

Version 4.2 for microsoft exchange server
Table of Contents

Advertisement

List of the most important settings in spamcatcher.conf:
Parameter name
approved_ip_list
blocked_ip_list
ignored_ip_list
rbl_list
rbl_max_ips
approved_domain_list Is a list domains and IP addresses in the email body, that are to be considered as allowed. Do
blocked_domain_list
ignored_domain_list
dnsbl_list
42
List of approved IP addresses. There's no need to add the list to the spamcatcher.conf file. You
can define it in the GUI of the program (see chapter
List of blocked IP addresses. There's no need to add the list to the spamcatcher.conf file. You
can define it in the GUI of the program (see chapter
List of ignored IP addresses. There's no need to add the list to the spamcatcher.conf file. You
can define it in the GUI of the program (see chapter
List of Realtime Blackhole servers to be used when evaluating messages. The RBL request
checks for presence of a specific IP address on a given RBL server. Subject to these checks are
IP addresses in the Received: sections in the mail header.
The entry format is as follows:
rbl_list=server:response:offset,server2:response2:offset2,...
Meaning of used parameters:
1) server - RBL server name
2) response - RBL server response if IP address was found (standard responses are 127.0.0.2,
127.0.0.3, 127.0.0.4., etc.). This parameter is optional, and if not set, all answers will be
considered.
3) offset - value from 0 to 100. Influences overall spam score. Standard value is 100, i.e. in case
of a positive check the message is assigned the spam score of 100 and is evaluated as spam.
Negative values lower the overall spam score of a message. Expect the 0 value also with
messages from senders in the approvedsenders file and the value 100 with messages from
senders in the blockedsenders file (see below).
Example 1:
rbl_list=ent.adbl.org
RBL check is performed using the
will be assigned a standard offset of 100 and marked as spam.
Example 2:
rbl_list=ent.adbl.org::60
RBL check is performed using the
will be assigned an offset of 60 which increases its overall spam score.
Example 3:
rbl_list=bx9.dbl.com::85, list.dnb.org:127.0.0.4:35, req.gsender.org::-75
RBL check is performed using the defined servers (from left to right). In case of a positive check
on
the offset of 85 will be added. If the check on
bx9.dbl.com
giving a response of
127.0.0.4
of answers other than 127.0.0.4. If a check is positive on
be decreased by 75 point (negative value).
Maximum IP addresses that can be sent to RBL server check. Total number of RBL requests is
the total amount of IP addresses in the Received: sections in the email header (up to the set
limit in rbl_maxcheck_ips) multiplied by the number of RBL servers set in the rbl_list. The value
of 0 means there is no limit to the maximum number of IP addresses that can be checked.
IP addresses on the ignored_ip_list (i.e. the Ignored IP addresses list in the ESET Mail Security
settings).
This parameter is applied only if the rbl_list is enabled (i.e. contains a minimum of 1 server).
not use to whitelist emails by sender's domain!
Is a list domains and IP addresses in the email body, that are to be considered as permanently
blocked. This is not a blacklist of sender's addresses! There's no need to add the list to the
spamcatcher.conf file. You can define it in the GUI of the program (see chapter
parameter setup
).
40
List of domains in the email body, that are to be permanently excluded from DNSBL checks
and ignored. There's no need to add the list to the spamcatcher.conf file. You can define it in the
GUI of the program (see chapter
List of DNSBL servers to be used in checks of domains and IP adrresses in the email body.
Format of entry is as follows:
dnsbl_list=server:response:offset,server2:response2:offset2,...
Details
Antispam engine parameter setup
Antispam engine parameter setup
Antispam engine parameter setup
server. If the check is positive, the message
ent.adbl.org
server. If the check is positive, the message
ent.adbl.org
offset of 35 will be used. The offset will not be applied in cases
Antispam engine parameter setup
will be positive
list.dnb.org
the spam score will
req.gsender.org
Antispam engine
).
40
).
40
).
40
).
40

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAIL SECURITY 4 - V4.2 FOR MICROSOFT EXCHANGE SERVER and is the answer not in the manual?

This manual is also suitable for:

Mail security 4

Table of Contents