Denon AVR-3802 Operating Instructions Manual page 31

Preset memory
By using the preset memory, the included remote control unit can be used to control other makes of video equipment. Note that this is not
possible for some models, however. In such cases, use the learning function (see page 34) to store the remote control signals in the remote
control unit's memory.
See page 37 for instructions on resetting the data stored in the preset memory.
1 Press the power ON/SOURCE button and the OFF button at
the same time.
• "SET UP" appears on the remote control unit's display.
OFF
2 Press the ENTER button.
3 Use the D and H cursor buttons to display "ENTER CODE" on
the remote control unit, then press the ENTER button.
The remote control unit's display switches as follows each
time the D and H cursor buttons are pressed.
ENTER CODE
CODE NO
LEARN
SYS CALL
RESET
AUTO SEARCH
4 After "SEL MODE" is displayed, the last selected mode is
set. Use the D and H cursor buttons to display the component
whose codes you want to store in the memory, then press
the ENTER button.
TUNING
BAND MODE
TUNING
The display switches as shown below each time the D
and H cursor buttons are pressed.
TV CD
DVD VDP
NOTES:
• The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control
unit's transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed on the
included list of preset codes.
• Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and
check.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR ........................................................................HITACHI
CD, MD, TAPE, CDR, VDP, DVD, DVD SETUP............DENON
DBS..............................................................................GENERAL INSTRUMENT
CABLE..........................................................................JERROLD
ON /
SOURCE
ENTER
SHIFT
TUNING
BAND MODE
TUNING
ENTER
SHIFT
ENTER
SHIFT
MD TAPE VCR
CABLE DBS VCR2
1
3, 4
2, 3, 4
5
5
1 2 3
4 5 6
7 8 9
0
6 "OK" is displayed when the signals are registered and the
mode is terminated.
7 To store the codes of another component in the memory,
repeat steps 1 to 6.
POWER
ON /
OFF
SOURCE
RC-883
REMOTE CONTROL UNIT
TV CD CDR/MD/ TAPE RECEIVER
VCR DBS/CABLE VDP DVD
DISPLAY MENU
SURR.
OSD
PARA.
SETUP RETURN
TUNING
A/B
MEMORY
BAND MODE
CHANNEL VOLUME
TUNING
+
+
SKIP ENTER
-
-
SHIFT
SKIP
MUTING
TUNER PHONO CD
1 2 3
CDR/TAPE VDP DVD
4 5 6
VCR-1 VCR-2/V.AUX TV/DBS
7 8 9
TV/
0 +10
VCR
TEST
SPEAKER
OUTPUT
TONE
SURROUND
DOLBY/DTS DSP 5CH / 7CH
SURROUND SIMU. STEREO
6.1 / 7.1
STEREO
DIRECT
SURROUND
INPUT
MODE ANALOG EXT.IN
SYSTEM CALL
CALL 1 CALL 2 BACKLIGHT
Referring to the included List of
Preset Codes, use the number
buttons to input the preset code (a
4-digit number) for
manufacturer of the component
whose signals you want to store in
the memory.
the
31