Page 1
S19 sol S79 sol Please read this carefully prior to installation. Store in a safe place for maintenance. aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com Quick Reference Manual Rel. 4.2, 08/2015, en-GB-DE (1) JD00000 10-EN...
6.1.3 Product-specific information Product-specific information (e.g. the data sheet) contains details of a particular type of module. aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com Page 4/19 Quick Reference Manual Rel. 4.2, 08/2015, en-GB-DE (1)
The original Multicontact® MC4 connectors are referred to as “MC4” in the data sheet. aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com Page 8/19 Quick Reference Manual Rel. 4.2, 08/2015, en-GB-DE (1)
For attaching the cable clip, use a suitable tool which can fully tighten at a de- tightening. fined low force. Avoid cable clips and tools which constrict or damage the cable aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com insulation when tightening. Page 9/19...
This applies to unlubricated screws with standard thread and strength class of 8.8 (minimum breaking load 29.2 kN). aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com...
All dimensions are shown in mm. Note: drawings are not always true to scale. The numerical values are binding. aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com Page 12/19 Quick Reference Manual Rel. 4.2, 08/2015, en-GB-DE (1)
10.8 Mounting drawings for modules with standard frames Mounting drawings for modules with standard frames Fig.9 Mounting drawing for modules S18, S19, S79 at load levels I and II 10.8 Mounting drawings for modules with standard frames 10.8 Mounting drawings for modules with standard frames...
Page 14
Fig.12 Mounting drawing for module S25, S75 at load level III Dimensions in mm. For a lay-in system, also refer to Ch. 10.5: „Insertion mounting“. aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com Page 14/19...
According to the standard IEC 61215, a photovoltaic module should have an insulation resistance of at least 40 M! • m ² Some inverters provide the measured insulation resistance via an interface. aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com Page 16/19 Quick Reference Manual Rel. 4.2, 08/2015, en-GB-DE (1)
Page 17
Distilled or demineralised water is often used by cleaning services but can damage Ethanol contains denaturants. Some denaturants can leave streaks behind or damage glass surfaces with frequent intensive use over long periods of time. aleo solar there fore advises against the use of distilled or demineralised water.
*Free service limited to max.10t per request/pick-up. Special conditions apply to quantities larger than 10t (i.e. replacement or decommissioning of large installations, etc.). aleo solar GmbH | Marius-Eriksen-Straße 1 | 17291 Prenzlau | Germany | info@aleo-solar.com Page 18/19 Quick Reference Manual Rel. 4.2, 08/2015, en-GB-DE (1)
Need help?
Do you have a question about the S59 and is the answer not in the manual?
Questions and answers