Searching Categories; Ipod ® Playback; Basic Operation - Denon AVR-488 Owner's Manual

ENGLISH
<SOURCE SELECT>
<ON/STANDBY>
[Front]
[1]
[6], [7]
[8], [9]
uiop
[MODE
SELECTOR 1]
[Rear]
[MODE]
uiop
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit


Searching Categories

STATUS
ui
1
Press o p
C A T :
2
o p
Use to select the category, then use
the desired station.
op
• "LOADING" is displayed while stations or data are being received.
• "UPDATING" is displayed while the encording code is being
[CHANNEL +/–] updated.
• "XM – – –" is displayed if the selected channel cannot be used.
[2]
iPod ® Playback
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, sold separately).
The operation can also be performed using the buttons on the
remote control unit.
[ENTER]
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
STATUS
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
[MODE
permitted for your private use as an individual. Be sure to comply
SELECTOR 2]
with applicable copyright legislation.
[iPod]
[ENTER]
.
Channel category
R o c k
ui
to select

Basic Operation

1
Make the necessary preparations.
q S et the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod's operating instructions.)
w Assign the Control Dock for iPod's input.
"System Setup" – "Input Setup" – "iPod Assign"
(vpage 22)
2
<SOURCE SELECT>
Either turn
select the input source assigned in step 1-w above.
R e m o t e i P o d
b If the displays above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
[MODE SELECTOR 1]
Set to "AUDIO" and
SELECTOR 2]
to "iPod/NETWORK".
(vpage 37 "Remote Control Unit Operations")
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" .
• Press <ON/STANDBY> and set the AVR-488's power to the standby
mode before disconnecting the iPod. Also switch the input source to
one to which "iPod Assign" is not assigned before disconnecting the
iPod.
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
[iPod]
or press to
[MODE