Related Manuals for Rockford Fosgate PUNCH 200ix
Summarization of Contents
Practice Safe Sound
Safe Sound Guidelines
Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss.
Specifications
Dynamic Power Rating
Measures output power at 14.4 Volts into various loads.
Continuous Power Rating
Measures RMS output power at 11.6 Battery Volts into various loads.
Signal-to-Noise Ratio
Measures the amplifier's noise floor relative to its output.
Dimensions
Physical size specifications for each amplifier model.
Bandwidth
Frequency range the amplifier can reproduce.
Damping Factor
Measures amplifier's control over speaker movement.
Frequency Response
Range of frequencies the amplifier can process.
Slew Factor
Measures amplifier's ability to handle rapid signal changes.
IM Distortion (IHF)
Intermodulation distortion measured by IHF standard.
Input Sensitivity
Range of input voltage the amplifier accepts.
Protection
Describes internal circuitry protecting the amplifier from damage.
Battery Fusing Rates
Specifies fuse ratings for power connections.
Fuse Type
Type of fuse used for protection.
Equalization
Details bass and treble adjustment capabilities.
Input Impedance
Electrical resistance of the amplifier's input.
Introduction
Operating Features Overview
Overview of the amplifier's key functional aspects.
Input Level Controls
Adjustable controls for matching source unit output.
Punch Equalization Controls
Controls for fine-tuning bass and treble response.
Cast Aluminum Heatsink
Feature providing efficient heat dissipation for reliability.
End Caps
Cosmetic feature for covering wires and providing a clean look.
Design Features
Internal Crossovers
Built-in active crossovers for flexible frequency filtering.
Device Protection Circuitry
Internal circuits protect against damage from shorts or speakers.
Gold-Plated Input and Output Terminals
Terminals plated for corrosion resistance and signal integrity.
Speaker Terminals
Heavy-duty terminals accepting 18 to 8 gauge wire.
Power Terminals
Terminals for battery B+ and ground connections.
REM Terminal
Terminal for receiving signal to turn amplifier on.
Gold-Plated RCA Jacks
Input jacks for reduced interference and signal degradation.
Input Sensitivity Controls
Adjustable controls for matching source unit output levels.
Punch Equalization Controls
Controls for bass and treble adjustment.
LED Power Indicator
Visual indicator for amplifier status.
Mounting Location
Trunk Mounting
Recommendations for mounting in a car trunk for cooling.
Passenger Compartment Mounting
Guidance for mounting under seats or under dash.
Sample Wiring Diagrams
Bridged Woofers Diagram
Diagram illustrating wiring for bridged woofer configuration.
3-Way System Diagram
Diagram showing a multi-speaker system wiring setup.
Complete System Diagram
Diagram illustrating a comprehensive speaker system configuration.
Troubleshooting
No Play - Remote Turn-On Light Off
Steps to diagnose why the amplifier is not powering on.
No Play - Remote Turn-On Light On
Steps to diagnose why the amplifier is on but not playing audio.
Amplifier Overheating
Troubleshooting steps for an overheating amplifier.
Amplifier Noise (Turn-On Pop)
Solutions for pop noise when the amplifier turns on.
Engine Noise (Whine)
Diagnosing and resolving engine-related noise in the audio signal.
Need help?
Do you have a question about the PUNCH 200ix and is the answer not in the manual?
Questions and answers