Toyota PRIUS Owner's Manual page 325

28p132
5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
"Rolling Code" type. Press and hold the
R
programmed HomeLink button. The ga-
rage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the
heading "Programming a rolling code sys-
tem".
6. Repeat steps 2 through 5 for each re-
R
maining HomeLink
another device.
Programming a rolling code system
If your device is
equipped, it is necessary
steps 1 through 4 under the heading
"Programming the HomeLink
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
R
door opener. Refer
by
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
3. Press and release the vehicle's pro-
R
grammed HomeLink
R
)
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
The ceiling mounted garage door opener
button to program motor should
R
HomeLink
garage door up/down.
4. Repeat steps 1 through 3 each remain-
"Rolling Code"
ing HomeLink
to follow
another rolling code system.
R
" before Programming an entrance gate/Program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place
transmitter 25 to 75 mm (1 to 3 in.)
to the owner's
away
HomeLink
Keep the indicator light on the HomeLink
in view while programming.
3. Press
HomeLink
4. Continuously press and release (cycle)
the hand- held gate/device transmitter
button every two seconds until step 5
button twice. The
is complete.
5. When
HomeLink
rapid flash after 20 seconds, you can
release both buttons.
now recognize the
unit and be able activate the
R
button to program
R
but-
your hand- held gate/device
from the surface of the
R
.
R
and hold the selected
R
button.
the indicator light on the
R
changes from a slow to a
309