Advertisement
12. Mount the Internet Camera
Server inside the camera
enclosure with the screws.
Temporarily leave one hole
unscrewed. This example shows
a TRENDnet TV-IP100W.
13. Ground the green wire on the
15AH-28B. Then screw in the last
hole.
14. Take the camera's power adapter
and cut about 7 inches from the
end the power connector using
the wire cutter. Note: This is the
AC/DC adapter that is included
with your Internet Camera Server.
15. Take a knife or box cutter and cut
along the middle to split the cable.
16. Cut the rubber insulation using a
knife or box cutter, then remove
the insulation with pliers to
expose the copper wiring.
5
English
Advertisement
