Download Print this page
Hide thumbs Also See for TV-H100:

Advertisement

Quick Links

Quick Installation Guide
TV-H100
H/W: V1

Advertisement

loading

Summary of Contents for TRENDnet TV-H100

  • Page 1 Quick Installation Guide TV-H100 H/W: V1...
  • Page 2 Table of Contents English ...................... 1 1. Before You Start ................2. Hardware Installation ................. Troubleshooting ..................11 Version 02.17.2009...
  • Page 3: English

    1. Before you start Package Contents TV-H100 Quick Installation Guide Mounting Bracket Hexagon screwdriver (1/4” L=6mm) Screws, washers and wall mount screws Installation Requirements The following items below are not included. Users must provide the items themselves. Make sure to have each item on hand before installation. Internet Camera Server (e.g.
  • Page 4: Hardware Installation

    2. Hardware Installation Note: Configure your Internet Camera Server to match your network before installing the device. 1. Remove the screws from the back of the camera enclosure. Save these screws. You will need to use these screws later. 2. Slide out the back end of the enclosure.
  • Page 5 4. Use the following screw to mount the Internet Camera Server to the metal bracket. 5. Screw the metal bracket back in to the TV-H100. 6. Connect the IR shelter to the Internet Camera Server (TV-IP312 and TV-IP312W only). 7. Take the Internet Camera Server's power adapter and cut about 4 inches from the end the power connector using the wire cutter.
  • Page 6 8. Take a knife or box cutter and cut along the middle to split the cable into two strands. 9. Use a wire stripper to remove the insulation to expose the copper wiring. 10. Run the power adapter and RJ-45 Ethernet cable from the base to the top of the mounting arm.
  • Page 7 13. Terminate the Ethernet cable. 14. Insert the Ethernet cable through the cable access hole. Then screw in the cap securely. 15. Remove one of the caps from the enclosure. 16. Insert the power adapter through the cap. 17. Insert the power adapter through the cable access hole.
  • Page 8 18. Connect the two ends of the power adapter back by twisting the copper wiring. Make sure you do not cross the copper wires. 19. Use electrical tape to seal the cables back together. Make sure to seal the individual strands separately.
  • Page 9 Installing External Antenna to Wireless Internet Camera 1. Remove the antenna from the back of your wireless Internet Camera Server. 2. Run the pigtail cable that comes with the TEW-ASAK from the base to the top of the mounting arm. 3.
  • Page 10 5. Insert the pigtail cable that comes with the TEW-ASAK through the cable access hole. Then screw in the cap securely. 6. Connect the pigtail cable that comes with the TEW-ASAK and the power adapter to the Internet Camera Server. 7.
  • Page 11 Mounting the Camera Housing 1. Place the mounting bracket against the wall and mark each of the four holes with a pencil. 2. Drill holes for the screws at each marked position. Make sure the drill bit matches the size of the provided white screws.
  • Page 12 For detailed information regarding the TV-H100 configuration and advanced settings, please refer to the User's Guide included on the Utility & Driver CD- ROM or TRENDnet's website at www.trendnet.com Register Your Product To ensure the highest level of customer service and support, please take a moment to www.trendnet.com/register...
  • Page 13: Troubleshooting

    You must use the TEW-ASAK with the TEW-L406/L412. See Installing External Antenna to Wireless Internet Camera in section 2 for more instructions. If you still encounter problems or have any questions regarding the TV-H100, please contact TRENDnet's Technical Support Department.
  • Page 14 Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
  • Page 15 Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com/register 20675 Manhattan Place Torrance, CA 90501 Copyright ©2009. All Rights Reserved. TRENDnet.