Performing The Initial Hardware Setup - HP Sa3110 - VPN Server Appliance Installation Manual

3
Next Step Next Step
Next Step Next Step
Hewlett-Packard VPN Server Appliance SA3110/SA3150/SA3400/SA3450 Installation Guide

Performing the Initial Hardware Setup

Performing the Initial Hardware Setup

Performing the Initial Hardware Setup Performing the Initial Hardware Setup Performing the Initial Hardware Setup
In this chapter, you complete the following tasks:
1. Physically connect the supplied DB-9 cable to your VPN
device and your PC.
2. Check power supply voltage setting.
3. Turn on the VPN device.
4. Create a console window with your terminal emulation
program.
5. Establish an initial session between your PC and your VPN
device.
6. Run your setup script.
7. Configure Syslog for troubleshooting.
8. Connect your device to the network.
Preparing to Configure a New VPN Device (page 3-2)
3-1