Adding A Description To An Ssl Proxy List; Configuring Back-End Ssl Servers In An Ssl Proxy List - Cisco 11503 - CSS Content Services Switch Configuration Manual

Chapter 5 Configuring Back-End SSL
Note

Adding a Description to an SSL Proxy List

Configuring Back-End SSL Servers in an SSL Proxy
List
OL-5655-01
Once you create an SSL proxy list, the CLI enters into the ssl-proxy-list
configuration mode.
(config-ssl-proxy-list[ssl_list1])#
To delete an existing SSL proxy list, enter:
(config)# no ssl-proxy-list ssl_list1
Delete ssl-list <ssl_list1>, [y/n]: y
You cannot delete an SSL proxy list if an SSL service is in use and contains the
active SSL proxy list. You must first suspend the SSL service to delete a specific
SSL proxy list.
To specify a description for an SSL proxy list, use the description command.
Enter the description as a quoted text string with a maximum of 64 characters,
including spaces.
For example, to add a description to the ssl_list1 SSL proxy list, enter:
(config-ssl-proxy-list[ssl_list1])# description "This is the SSL list
for www.brandnewproducts.com"
To remove the description from a specific SSL proxy list, enter:
(config-ssl-proxy-list[ssl_list1])# no description
This section discusses creating one or more back-end SSL servers for an SSL
proxy list. Use the backend-server command to define an index entry in the SSL
proxy list that you then use to configure specific SSL parameters associated with
the SSL proxy list. An SSL module in the CSS uses the SSL proxy list to initiate
a connection to a back-end SSL server. You must define a back-end server index
number before configuring SSL proxy list parameters. You can define a maximum
of 256 back-end SSL servers for a single SSL proxy list.
Adding a Description to an SSL Proxy List
Cisco Content Services Switch SSL Configuration Guide
5-3