Operator’s manual A75 ---A95 , A75 ---A95 Serial numbers of your tractor In open cab models the serial numbers are on the same locations Type plate EEC ....Engine number .
Page 3
Main table of contents The Operator’s Manual is divided into 12 main parts, using the letters A, B, C ... L. These are further sub divided into number sections. There are four levels of titles. E.g. on the marking D.1.3 the letter D tells that it is the main part D, Instruments and controls.
You should order spare parts according to the instructions given in the il- lustrated parts catalogue. Due to the continual development of Valtra Inc. products, the content of this manual may not always correspond with the new product. Therefore, we retain the right to make alterations without prior notification.
Extensive repairs to the regards traffic safety and occupational health and safety. braking system should be undertaken only by Valtra approved service personnel. When implements or Safety regulations applicable for different types of working...
Page 8
19 Trailer --- A trailer should only be coupled to the drawbar. A loaded drawbar must always be lowered with the three---point linkage. Check that trailer brakes are operating property and observe any special instructions issued by the trailer manufacturer. CAUTION: When the tractor is towing a trailer the brake pedals must be locked together.
24 Attaching implements --- Care must be taken when kept inside the cab, especially not above the right side implements are being attached. There is a risk of an panel. accident if the tractor or implement should move. It is only When using a mobile phone in the tractor it is safe to enter the implement if the parking brake is applied recommended that it is connected to the outside antenna.
Page 10
Roll Over Protective Structures B 1.1. Fig. 6 A B1 --- Check the seat belt for damage. A damaged seat belt must be replaced (Fig. 6). Fig. 5 A Roll Over Protective Structure (ROPS) and seat belt Damage to the ROPS B 1.1.2.
, A95 makes serving easier. The tractor is fitted with a double clutch which acts against The models dealt with here belong to the Valtra’s small the flywheel, fully synchronized gearbox, an shuttle unit, category tractor series. differential lock, hydrostatic steering, working hydraulics...
Page 12
10. Engine heater plug 11. Fuel injection pump Preheating of engine induction air, electric 12. Engine air intake prefilter system Windscreen washer container A75n, A75 ---A95 cyclone cleaner (as in picture) Battery A85n, A95n ejector Prefilter, fuel system, water trap in lower part 13.
Page 13
A C4 Right side of tractor: 5. Suction strainer, hydraulic system 6. Starter motor 1. Turbocharger, behind the thermal protection 7. Fuel filling opening 2. Thermostat housing 8. Hand priming pump, fuel system 3. Alternator 4. Hydraulic pump C. General description ---12---...
Page 14
69---5,3 Rear view of tractor: 10. Incorporating breather, hydraulic system 11. Oil filling, hydraulic system 1. Quick---release couplings, auxiliary hydraulics 12. Dipstick, hydraulic system 2. Trailer socket 13. Auxiliary hydraulic system return coupling 3. Detent for disengaging draft control (not on electro 14.
Page 15
A C6 Front view of tractor: Not in open cab models. 1 DIN---socket for current, max 8A (current on, when the parking lights are on) 2 Front linkage (extra equipment) 3 Front power take---off (extra equipment) C. General description ---14---...
Traditional use of clutch pedal is, however, always possible. A C5 The tractors have 4---stroke direct injection diesel engines: Three---cylinder engine, turbocharged; ---A75n, A75 Four---cylinder engine, turbocharged; ---A85n, A95n Three---cylinder engine, turbocharged and intercoolered; , A95 C. General description...
Gearbox Power shuttle C 4.2. C 4.4. A3565---18 65---8,5 The speed gearbox has four synchronized gears which The shuttle unit is synchronized and has a pressure are controlled with a speed gear lever. lubrication system. The forward---reverse shutle is In front of the gearbox there is fitted a shuttle unit. controlled with the lever nearest to the driver.
Steering system Power take---off C 4.6. C 6. A3565---21 The power take---off works fully independently of the gearbox. It has its own clutch disc in the twin clutch which is attached to the flywheel. Engagement and disengagement of the power take---off is via the PTO clutch control lever of the clutch disc.
Hydraulic system C 7. A C8 When an electro---hydraulic Autocontrol B (ACB) is fitted, the control levers are replaced with knobs and switches. Pre---programmed/programed functions: --- Draft control/position control combining ratio plus sensi- tivity on the regulator, the sensitivity adjustment is auto- matic.
Need help?
Do you have a question about the A95n and is the answer not in the manual?
Questions and answers