Denon DN-C680 Operating Instructions Manual page 24

16) "Delay OFF (***ms)"
Delay OFF (***ms)
17) "PIayLock ON (OFF)"
PIayLock ON
* PIayLock OFF
18) "FR Disp ON (OFF)"
* FR Disp ON
FR Disp OFF
19) "CD-R TOC (NO TOC)"
CD-R TOC .
* CD-R NO TOC .
20) "CD-R SkipON (OFF)"
CD-R SkipON .
* CD-R SkipOFF .
21) "9600 (19200) bps"
* 9600 bps
19200 bps
22) "Switch ENA (INH)"
* Switch ENA
Switch INH
23) "Player ID (**1"
Player ID (**)
24) "Remote EMA (INHI"
* Remote ENA
Remote INH
25) "St. Tally ON (OFF)"
* St. Tally ON
St. Tally OFF
26) "(******) Tally"
* INDEX2 Tally
INDEX3 Tally
27) "Fader Pause (Play)"
* Fader Pause
Fader Play
28) "Stereo (Mono)"
* Stereo
Mono
29) "Pos ON (OFF)"
Pos ON
* Pos OFF
30) "Preset Clr? (Init. Preset)"
Preset Clr?
* Init. Preset
31) "Ver. xxxx"
: Set the time for delayed start after the play start operation. (*OFF/100m/200m/300m)
: Inhibit all operations other than the PLAY/ PAUSE, TIME and PLAY MODE buttons during playback.
: Enable all functions during playback.
: Display the frames on the time display during playback.
: Do not display the frames on the time display during playback.
(The frames are displayed in the manual search, standby, pause and end monitor modes.)
: Play normal CDR discs containing TOCs.
: Play CDR discs not containing TOCs.
: Play skip tracks on CDR discs.
: Do not play skip tracks on CDR discs.
: Set the baud rate to 9600 bps.
: Set the baud rate to 19200 bps.
: Enable operation of all the switches on the front panel.
: Inhibit operation of all panel switches other than those used for presetting operations.
: Set the player ID.
(The ID can be set to OFF or to 0 to 15. The initial setting is "OFF".)
: Enable input of control signals to the parallel remote connector.
: Inhibit input of control signals to the parallel remote connector.
: Output standby tally from parallel remote connector.
: Do not output standby tally from parallel remote connector.
: Output index 2 tally signal to remote pin (17).
: Output index 3 tally signal to remote pin (17).
: Start playback when remote fader pins (9-10) are short-circuited and pause when pins are open.
: Start playback when remote fader pins (9-10) are short-circuited and continue playback when pins are open.
: Output L and R stereo signals from the output connector.
: Output mixed L and R signals from the output connector.
: Read Pos codes on CD and CDR discs.
: Do not read Pos codes on CD and CDR discs.
: Clear the presettings (set to the initial factory values).
: Do not clear the presettings.
: Display the microprocessor version. ("xxxx" is a number.)
25