FIA NP98-32 Installation Instructions

If you have any comments or concerns,
please feel free to contact our
customer service department at:
Toll-free: 1-800-835-0438
OR
Email: info@gofia.com
Thank you for purchasing one of our fine quality products. Your seat cover is engineered from high quality materials
and designed with precision to give you a long-lasting, well-adjusted fit.
1) Remove headrests. (see note below)
2) Slip cover over backrest and pull down firmly (see
airbag warning below)
3) Tuck flaps under backrest and attach to velcro at
back
1) Move seat to most forward and uppermost position
2) Place cover on seat cushion ensuring long side strap
is on the door side
3) Pass back flap of cover with straps through crevice
4) Feed straps under seat and buckle to front of
cushion cover
NOTES:
1) SELF-LOCKING SUPER-GRIP® BUCKLE:
2) HEAD REST REMOVAL:
Push in side release buttons
- Lift off
(If unable to remove
consult dealership)
WHEN INSTALLING SEAT COVERS:
1) Seats with integrated seat airbags must be covered only with seat covers designed with openings. Make sure that the
openings in the sides of the seat covers are positioned so that the seat covers do not block or interfere with the deployment of
the air bag. The attached flap tucks inside the cutout and should be able to open freely in case of deployment.
2) Constantly check your seat covers to ensure they are properly positioned to allow for complete air bag deployment.
LIMITATION LIABILITY: The manufacturer shall not be liable for any damages or for the breach of any warranty, express or implied, whether of merchantability or fitness for any purpose or
otherwise, or for any other obligation or liability arising out of the installation of the seat covers or the movement of the seat covers after installation.
Fia Inc. Winnipeg, Canada R3L 0N3 Telephone (204) 475-0515 Toll-Free: 1-800-835-0438
Fax: (204) 284-8246 E-Mail: info@gofia.com Website: www.gofia.com
SEAT COVERS
SUPER-GRIP® THE SLIP RESISTANT FASTENING SYSTEM
INSTALLATION INSTRUCTIONS
NP98-32/ Oe38-32/ SL68-32/ SP88-32/ TR48-32
A) BACKREST COVER
B) CUSHION COVER
WARNING: DO NOT BLOCK AIR BAGS
BY
FEATURING
FOR
4) Adjust velcro to equalize tension
5) Replace headrest (see note below)
5) Pass long side strap through the opening between
the seat and the molded plastic and under the seat
6) Buckle to the other side
7) Adjust straps to equalize to equalize tension
3) RE-INSTALLATION OF HEADRESTS
A) Ensure pre-cut holes in seat cover align with holes
in headrest base.
B) Replace headrests
09-04-13