Advertisement
Quick Links
60-120 min
Cutting Not
Required
Drilling Not
Required
Part List
L-Shape Clamping Bracket
www.tacautoparts.com
UNIVERSAL HITCH STEP
2" Hitch Receiver
FITS:
Torque & Tools
Fastener
Tightening Torque
Size
(ft-lbs)
□ 6mm
□ 7-8.5
■
■
8mm
18-20
■10mm
■
35-40
□12mm
□ 60-70
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
ASSISTANCE IS RECOMMENDED.
Hitch Pin Safety Clip
PART #: HT-U08
Wrench Required
□ 10mm
■
13mm
■
16mm
□ 18mm
Draw Bar Welded
Bracket
Hitch Step
Customer Support: tac-office@tacautoparts.com
Allen Wrench
Required
□ 4mm
□ 5mm
□ 6mm
□ 8mm
Hitch Pin
10mm U-Bolt
Advertisement
Related Manuals for TAC HT-U08
Summary of Contents for TAC HT-U08
- Page 1 UNIVERSAL HITCH STEP PART #: HT-U08 2” Hitch Receiver FITS: Torque & Tools Fastener Tightening Torque Allen Wrench Wrench Required 60-120 min Size (ft-lbs) Required □ 6mm □ 7-8.5 □ 10mm □ 4mm ■ ■ ■ □ 5mm 18-20 13mm ■10mm...
- Page 2 10mm Hex 10mm x 27mm 10mm Lock 8mm x 25mm Nuts Flat Washers Washer Combo Bolt FIG 2 STEP 1 Select the Draw Bar Welded Bracket. Insert the Bracket into the receiver hitch tube and align the Rear holes in the tube with the mounting holes on the Bracket, (Fig 1).
- Page 3 FIG 5 STEP 3 Rear Select the L-Shaped Clamping Bracket and the 10mm U-Bolt. Place the L Bracket under the Draw Bar and up against the end of the receiver hitch. Insert the 10mm U-Bolt over the Draw Bar and down through the L Bracket.
Need help?
Do you have a question about the HT-U08 and is the answer not in the manual?
Questions and answers