ITC Sequoia TS400X Installation Instructions

Sequoia
™
Part#: TS400X, TR400X & TL400X
PARTS/TOOLS NEEDED:
Table Base Floor Base
INSTALLATION CONSIDERATIONS
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not sit on or lean on table, intended for use as a table only.
1.
Mount the floor base into solid floor structure (wood,
fiberglass, etc.) using #10 phillips oval head screws.
3. 1
Insert The Leg :
Line up the hole in the base with the blades on the leg. Push the leg down
and twist clockwise until you feel some resistance, continue to turn until
the leg clicks into place. Twist collar clockwise to tighten.
2
Remove The Leg : Twist collar counter-clockwise to loosen. Twist the leg
counter-clockwise until you feel resistance, continue to turn until you feel a
click and the blades match up with the hole. Pull up to remove.
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
Table Leg
Table Leg
1
INSTALLATION INSTRUCTIONS
#10 Phillips Oval Head
Screws
2.
Mount the table base onto table top (customer provid-
ed) using #10 phillips oval head screws. Make sure the
weight of the table top is evenly supported over the
table leg.
For warranty information please visit www.itc-us.com/warranty-return-policy
Power Drill
(Not Provided)
(not provided)
Turn past bump
2
out on the
bottom
Rev B • 02/16/18
Page 1 of 1