Table of Contents
Advertisement
No digital broadcast signal
direction of the TV broadcast base. Adjust the position for the best reception.
Digital terrestrial TV's determined by government policy. The broadcast bases
will be increased in order to cover the entire country. Please check the related
government website for more information about the strength of digital
terrestrial TV broadcast in your area.
You can check how good the signal is in your location by performing a simple
test. Please plug in the antenna into an analog TV set. Then check if this TV
set can receive a good TV signal. If the picture is not clear, the digital terrestrial
TV broadcast signal is about the same. The difference is when the program
data is not sufficient, you may see a blank screen or the video will be
scrambled.
Digital TV broadcast is different than normal analog TV. You will see no picture
instead of noisy or blurred picture when the signal is too weak. Make sure you
have a good antenna and strong digital TV signal in your location. Or you will
have no TV picture at all.
Why won't my PC start?
Don't panic. The most common reason for this is because you connected the
ATX power switch cable to the wrong pins on the mainboard. Verify the
position of the power patch cable on the mainboard. Check the mainboard
documentation to verify the position of the connector for ATX power switch
cable.
If that doesn't help, remove the TV card and restart your PC. If you still cannot
turn the computer on, the problem is not caused by VideoMate TV. Recheck
the ATX power switch cable connection.
30
In order to receive digital terrestrial TV
broadcasts, an antenna is crucial. Digital
terrestrial TV broadcast uses about the
same wave frequencies as analog TV (UHF).
It's recommended to have a fishbone-like
antenna (see figure) on the roof for
reception.
Make sure you position the antenna in the
Note
Advertisement
Table of Contents
