Page 2
REQUIRED TOOLS Panel Remover Phillips Screwdriver Installation Instructions 90° 90° 3. remove the two pins holding the headlight 4. remove the headlight. housing in place. 5. remove the headlight connectors for the 6. take off the turn signals so we can splice the high and low beam.
Page 3
9. Splice the black(-) and brown(+) parking 10. Connect the headlight plugs into the light to the new headlight. Red (+) wire new headlight. to brown and black(-) to black. 11. Plug and twist the turn signal light. 12. Put the headlight back into the housing and use the pins to lock in the headlight.
Need help?
Do you have a question about the WJ10-0214 and is the answer not in the manual?
Questions and answers