AUDIOLINE WT50 Manual

WT50
1
2
3
4
5
6
1 Headset socket 6 DOWN/Change
2 Charging socket channel
3 On/Off and volume 7 Send ringer signal
4 Send button (PTT) 8 UP/Change channel
5 Monitor button
Guarantee
This product is guaranteed for a period of 12
months from the date of purchase. Proof of
purchase is required for any service or support
required during the guarantee period. This
guarantee shall not apply to a fault caused by an
accident or a similar incident or damage, liquid
ingress, negligence, abnormal usage, not reasonably
maintained or any other circumstances on the
purchaser's part. Furthermore, this guarantee shall
not apply to a faults caused by the use of poor
quality batteries, battery leakage, corrosion or
similar events related to batteries. This guarantee
does not in any way affect your statutory rights.
Australia
Downloaded from: http://www.guardianalarms.net
Version 1.0
English
Area of use
The handsets are intended for indoor and outdoor
use. However, they are not resistant to rain, misuse,
water or other careless treatment.
Under ideal conditions (no obstacles between the
handsets) the handsets will transmit up to 3 km.
Batteries
The unit requires three quality AAA 1.5V batteries
to function (not included). New alkaline batteries
8
will last for approximately 25 hours in standby or
2-3 hours talk time.
7
1. Press the round button in the middle of the clip
and rotate the belt clip a quarter turn, remove
the battery cover.
2. Insert the batteries ensuring correct polarity is
observed, refi t the battery cover and rotate the
belt clip.
3. Switch the handset on/off by turning the
volume control until a click is heard.
Channel lock
Press and hold CALL and one of the
simultaneously until the display shows the lock
symbol. Only the / buttons are locked.
v V
Australia and New Zealand
If you believe this product is malfunctioning, please
refer to the relevant section and/or consult the
troubleshooting guide in this manual to ensure that
you have followed the instructions carefully. As an
alternative you can visit our web site for FAQ's or
send an e-mail for a prompt reply.
AUSTRALIA
DORO Australia Pty Ltd
PO Box 6760
Baulkham Hills BC NSW 2153
Australia
Consumer Support
Ph: 1300 885 023
Fax: (02) 8853-8489
Email: support@doro.com.au
Web site: www.doro.com.au
Complies with AS/NZS 4635 Complies with AS/NZS 4635
English
Use
1. Select the same operating channel using
Change channel if it is already in use.
2. Press and hold PTT (Push To Talk) while you
speak.
3. If there is no answer, send a ringer signal using
CALL.
Please note!
If the handsets are unable to communicate it may be that you If the handsets are unable to communicate it may be that you If the
are using different channels, the batteries are running low or
there is there is too great a distance between the handsets. there is too great a distance between the handsets.
The call button will only operate once in any 60 second cycle.
In other words after the call button has been operated it will
not work again until 1 minute later. This is an approvals
requirment.
Monitor function
If the signal is weak, press and hold MON to listen
for any incoming signals.
/ buttons
v V
NEW ZEALAND
Atlas Gentech (NZ) Limited
Private Bag 14927
Panmure
Auckland
New Zealand
Consumer Support
Ph: 0900-500-25 (Toll Call)
Fax: (09) 574-2722
Email: support@atlasgentech.co.nz
N13 Z109
Optional A Pack
/ .
v V V V
Headset
The headset socket located next to the aerial is
labelled (SPK/MIC). When connecting a headset
from the optional A Pack, use the PTT button on the
cable to talk.
Please note!
The headset ringer signal and headset volume may initially be very
loud. Adjust the volume control immediately you connect the headset.
Charging
Warning!
When charging never use ordinary (non-
rechargeable) batteries in the handset,
since this will ruin the equipment. The
guarantee does not cover this type of
damage.
Upon installing the supplied rechargeable batteries ensure
correct polarity is observed, connect the adapter to the
PTT/CHG
before charging will occur and cannot be used to transmit
while charging. The battery indicator will stop fl ashing when
charging is complete (approximately 8 hours).
Please note!
When the unit is installed, the batteries must be charged for 10-15
hours before using the handset. The recharging system used in this
model may result in the handset and the batteries becoming warm.
This is normal and will not damage the equipment.
Operating Channels and Frequencies
Channel MHz Channel
1 *................ 476.425 15.................476.775
2 *................ 476.450 16.................476.800
3 *................ 476.475 17.................476.825
4 *................ 476.500 18.................476.850
5 ** .............. 476.525 19.................476.875
6 *................ 476.550 20 ................476.900
7 *................ 476.575 21.................476.925
8 *................ 476.600 22 ! ..............476.950
9 .................. 476.625 23 ! ..............476.975
10 ................ 476.650 24.................477.000
11 ................ 476.675 25 ................477.025
12 ................ 476.700 26 ................477.050
13 ................ 476.725 27.................477.075
14 ................ 476.750 28 ................477.100
* These channels are the repeater access channels. This product is not
repeater enabled. Other callers may be heard on the designated channels but
communication with them is unlikely to occur.
** Designated emergency channels.
! Speech telephony is not permitted on these channels.
English
socket. The handset must be switched ON
MHz Channel MHz
29 .................477.125
30.................477.150
31 *...............477.175
32 * ..............477.200
33 * ..............477.225
34 * ..............477.250
35 ** .............477.275
36 * ..............477.300
37 *...............477.325
38 * ..............477.350
39.................477.375
40 .................477.400