Easyflex 3500-20C-3 Installation Instructions

INSTALLATION INSTRUCTIONS
1
Clear the installation area of
grass, loose soil, mulch, and
debris. Create a score along the
installation area with a spade or
shovel.
HELPFUL TIPS & INFORMATION
Preparation:
Allow the edging to relax in the sun to allow for
thermal expansion. Installing the edging when
expanded and pulling tightly can reduce undesirable
waves in straight installations.
Enough anchoring stakes are included to
accommodate a typical installation. Certain conditions
and landscape designs will require additional stakes,
which are available in stores and online.
To connect two pieces of edging, overlap the edging
ends and place the stake hook over the top of both
edging pieces.
Always use proper safety precautions when cutting
and staking edging. Protective eyewear and gloves
are recommended during installation.
Manufactured by Westlake Dimex
Marietta, Ohio
2
Insert the edging so that the
edging height above ground is 2
inches or less. Stake edging
along installation as needed to
secure the design.
Cutting:
Edging can be cut with a ne-toothed saw or
heavy-duty snips. For best results, cut between scallops.
3
Back ll and tamp soil against the
edging on both sides to secure
the wall. Spread mulch or other
ground cover up to the wall of the
edging.
Question/Comments? Contact us at
customersupport@dimexcorp.com