Bonsaii L418-C Operating Instructions

Operating Instructions:
Place the laminatoron a flat, secure, stable surface.
1.
2. Plug the power cord into a standard 120V outlet.
3. Push the control switch to 3 mil or 5 mil position(located on the front of the
machine), the red light will come on, the green light is flashing, indicating that
the machine enters the preheating state. The Power light will illuminate when
the machine is on, and will turn off when the machine is off.
TIPS: The 3 mil setting should be used for laminating standard printer paper
or lighter weight items. The 5 mil setting should be used for photo paper,
business cards and other thick items.
4. Wait for the green Ready light to come on, which indicates the laminator is
warm enough for use.
5. Insert the item to be laminated into Bonsaii Thermal Laminating Pouch so that
your item is close to the sealed (closed) edge of the pouch. Do not cut the
pouch if your item is smaller than the size of the pouch or the pouch will likely
become jammed inside the laminator.
TIPS: You can trim the pouch after laminating.
6. Feed the pouch closed/sealed-edge first, straight into the laminator inlet.
Hold the pouch until the machine moves it forward.
7. The laminated item will automatically exit the outlet of the laminator. Do not
pull the pouch through the laminator. If the pouch should become jammed or
not feed correctly, push the ABS buttom (located on the back of the
machine) and pull the pouch though the laminator.
8. Remove the pouch after it has stopped moving and allow the sheet to cool on
a flat surface. It may be necessary to laminate thicker items twice to
completely seal the pouch.
9. When finished laminating, turn off the control switch to OFF the laminator.