Indicator Led - DigiTech WEAPON Manual

7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push these pins in to release the pedal from the pedal chassis
exposing the battery compartment. (See the Battery Replacement
Diagram at the end of this Owner's Manual.)
8. Pedal
Press the pedal to turn the effect on and off.
9. Out 1(Amp) Jack
Connect this output to your guitar amplifier.

10. Indicator LED

This LED indicates when the effect is turned on. If the LED
becomes dim or does not light when using battery power (with the
cables connected), the battery needs to be replaced.
11. Out 2 (Mixer) Jack
The Out 2 (Mixer) output has been specifically designed for use with
a full range audio system. This means that it is to be plugged directly
into a mixer or recording device connected to full range speakers
for optimal performance.