Download Print this page

IKIMI KD-ZK Manual

4 drawer file cabinet

Download this manual

Installation video

Need help?

Do you have a question about the KD-ZK and is the answer not in the manual?

Page 1 Installation video...
Page 2 ×1 ×1 ×1 ×1 ×1 ×2 ×4 ×4 ×4 ×4...
Page 3 A×2 B×4 C×24 D×30 E×4 16mm 12mm M4× M4× M5× 0.6inch 0.3inch 0.47inch...
Page 4 put three screws to hold part 1and 2 into place. D×3 D×3...
Page 5 Top down with a soft hammer until it is flat with the bottom of the side panel put twelve screws to hold part E into place. E×4 D×12...
Page 6 A×2 B×4 put eight screws to hold part 6 into place. D×8...
Page 7 put four screws to hold part 5 into place. D×4...
Page 8 Bend the slde walls of the drawer to vertical Tap lightly Rear plug put six screws to hold part 9 into place. C×24...
Page 9 the file hanging bar can be put inside Must step:A First slide the steel ball to the front of the cabinet's outer slide. B: Lnsert the inside railway course on both sides of drawer on the outside railway course of cabinet at the same time.Two people must put the drawer flat and insert it slowly and synchronously.After inserting it to the end,pull it out slowly twice,the slide track works...