Mynt3d MP012-WH Troubleshooting

Troubleshooting
My pen won't heat up.
•
Make sure you are pressing the feed button to begin heating.
• Make sure the power cable is connected securely and the display is on.
•
If the display does not turn on, try an alternate AC to USB adapter if
available.
•
If heating mode begins but current temperature does not rise, replace the
nozzle.
My pen heats up, but filament does not extrude.
•
Try setting the speed control to fast.
•
Make sure the feed gear has engaged the filament and it is loading into the
pen.
•
If filament gets to the nozzle and then the motor struggles or slows
down, STOP and unload the filament.
•
Try cutting a fresh end on the filament.
•
If none of these suggestions help, you can try opening the service door and
removing the nozzle to inspect for blockages.
: