Related Manuals for Mynt3d Junior2
Summary of Contents for Mynt3d Junior2
- Page 1 User Manual Please read through this user manual completely before use. www.mynt3d.com...
- Page 2 WARNING This product is suitable for children over 3 years old, and adults. It is strictly prohibited to put any other material into the filament hole. It is prohibited to use filaments provided by other companies. WARNING DO NOT use this appliance near bathtubs, showers, basins or other vessels containing water.
- Page 3 Verify you received all the components. 3. User Manual 1. 3D Printing Pen 4. Low Heat Filament* 2. USB Power Cable * PCL compatible only! Using ABS or PLA will damage the 3d pen and void the warranty! Features and Controls Nozzle Filament Load Button / Extrude Button...
- Page 4 Operation Instructions 1. Press the power button for 3 seconds to initiate heating. Heat indicator will be red. 2. When the heat indicator light turns green, press the filament load button to start feeding. Load filament into the hole at the end of the pen.
- Page 5 Standby / Inactivity After about 2 minutes of inactivity the pen will power off automatically. Filament will automatically reverse out of the pen. Battery Charging Instructions 1. When the battery indicator turns red and flashes slowly, it is time to charge the battery.
- Page 6 Nozzle Removal Instructions 1. Remove screw from the bottom of the pen. 2. Remove the end cap of the pen. 3. Pry up the outer casing of the pen, separating the bottom from the top piece. 4. Remove 2 screws on the inside of the pen. Wiggle out nozzle.
- Page 7 Limited 1 Year Warranty We stand by our products and offer a 1 year limited warranty that covers defects in manufacture. For more information visit: www.mynt3d.com/pages/warranty Contact information: MYNT3D 4041 Soquel Dr Ste A-148 Soquel, CA 95073 support@mynt3d.com (800) 695-5994...
Need help?
Do you have a question about the Junior2 and is the answer not in the manual?
Questions and answers