Omega J8007S Assembling Manual

Assembling Your New Omega Juicer and Nutrition System
Enclosed is the List of Accessories you will receive with your Omega Juicer and Nutrition System
Assembling your Omega Juicer and Nutrition System to start your Juicing Session
including Nut Milks:
1. Slide the Locking Clip to the Open Position
2. Attach the Chute/Drum to your Juicer and Nutrition System and slide the Locking
Clip to the Closed Position.
3. Insert the Auger (There will be about a ¼" from the back of the Auger to your Motor
Housing).
4. Slide the Juicing Screen over the Auger with the Rectangle Tongue sliding over the
bottom portion of the Auger.
5. Attach the Adjustable End Cap to the Chute/Drum.
6. If in need use the Pusher (Plunger) to apply Slight Pressure when Feeding your
Produce down the Chute of your Drum.
Assembling your Omega Juice and Nutrition System to Process Nut Butters and Sorbet:
1. Slide your Locking Clip to the Open Position.
2. Attach the Chute /Drum to your Juicer and Nutrition System slide the Locking Clip to
the Closed Position.
3. Insert the Auger.
4. Slide the Blank Cone (The Black Cone without the Mesh) over the Auger with the
Rectangle Tongue sliding over the bottom portion of the Auger.
J8007S, J8008C, J8006HDS, J8006HDC Juicer
A. Hopper
B. Chute
C. Drum
(Your Chute and Drum are one Part Connected together)
D. Locking Clip (The Locking Ring is Pre-Assembled on your Juicer and
is only Removed for Cleaning Purposes)
H. Auger
I. Blank Cone (The Black Cone without the Mesh Filter)
J. Juicing Screen (The Black Cone with the Mesh Filter)
K. Adjustable End Cap
L. Blank End Cap
M. 4 Pasta Nozzles
N. 2 Breadstick Nozzles
O. Sieve
P. Cleaning Brush
Q. Pulp Container
R. Juice Container
S. Pusher