NKCELL POWER B0CLXXL4L3 Manual

SPARE TIRE BRAKE LIGHT INSTALLATION STEP
STEP 1
Remove your spare tire using a
19mm socket.
STEP 4
Set the spare tire brake light on the studs
of the spare tire mount. Make sure that the
wire is in the upper position to ensure you
have enough length.
Attention:
1.The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
2.Please feel free to contact your distributor if you have any kind of question about your purchase.
SPARE TIRE BRAKE LIGHT
COMPATIBLE WITH JEEP WRANGLER 2007-2018JK/JKU
PLUG AND PLAY LOSSLESS INSTALLATION
Uasge:Spare Tire Wheel Brake Light
Voltage:12v DC
Color Of Light:Red
LEDs:405PCS
Waterproof:IP67
Diameter:13.8 Inch(350mmx350mmx23mm)
STEP 2
Open the rear cargo door and remove the
4 screws holding the factory 3rd brake light
in place using a T20 Torx driver.
STEP 5
Plug the factory 3rd brake light in to the
brake light ring harness,Plug the brake
light ring into the factory harness.
NKCELL POWER
STEP 3
Unplug the factory 3rd brake light.
STEP 6
and the spare tire. The installation is
complete. Reinstall back the plastic
shell of the high brake light.