Automatically Set The Key And Scale; Manually Set The Key And Scale; Reset The Musiq Tm Feature's Memory - DigiTech HARMONYMAN Owner's Manual

Using the HarmonyMan

Automatically Set the Key and Scale

1. Make sure the musIQ
2. Make sure the On LED is not lit. If it is lit, press the Harmony On/Off
footswitch once.
3. Play some chords until one of the Harmony Key Display LEDs turns
yellow and then turns green. The key and scale have now been set. Note
that even when a Harmony Key LED is yellow, that key and scale will be
used if the harmonies are engaged.

Manually Set the Key and Scale

Press and hold the Memory Select footswitch for approximately 1 second.
1.
The musIQ button will flash and a red LED will cycle around the Harmony
Key Display.
2. Continue to hold down the footswitch and strum a chord to set the key
and scale accordingly. For example, if you strum an Am chord, the C/Am
LED in the Harmony Key Display turns green. The output is muted when
manually setting the key and scale.
Release the Memory Select footswitch.
3.
Reset the musIQ
If you have manually set the key, but want the HarmonyMan
detect the key again, you can reset the musIQ feature's memory and turn the
musIQ feature back on. Resetting the musIQ memory erases any chordal
history that previously existed.
Make sure the On LED is not lit. If it is lit, turn it off using the Harmony
1.
On/Off footswitch.
2. Press and hold the Memory Select footswitch for approximately 1 second.
The musIQ button flashes and a red LED cycles around the Harmony Key
Display.
3. Release the Memory Select footswitch without strumming a chord. In this
example, any previous note information in the musIQ feature's memory
is cleared and the musIQ feature is enabled. This will result in faster key
tracking, for example, when starting a new song after a previous song has
ended.
button is lit. (If it's not lit, press it once.)
TM
Feature's Memory
TM
TM
to automatically
TM
9