Amazon B00Q3KFX8U Troubleshooting Manual

!
WARNING: DO NOT ATTEMPT TO REPAIR BY OPENING THE SHREDDER HEAD. THIS WILL COMPLETELY VOID THE PRODUCT WARRANTY.
No power to the shredder or does not shred paper
 Check power outlet
1) Make sure power cord is plugged
into a functioning 120V standard
household power outlet.
Or, try using a different working
outlet.

Cool down time
2) Overheating with extended use: In
the event that the shredder has
shred continuously beyond the max-
imum running time and overheated,
30
the unit will automatically shut off.
If this happens, switch the shredder
Min
Off for 30 minutes or longer before
resuming normal operation.

Check control button
is in Auto mode
3) • Check if the control switch is in
• Check if the head unit portion of
Shredder runs continuously

Unplug power
!
Warning:
DO NOT USE CANNED AIR.
1) Unplug the machine from the wall

Clean sensor
socket.
Cotton swab
2) • Find the activation sensor in the
• Use a cotton swab to gently wipe
TROUBLESHOOTING GUIDE
Auto position.
the shredder is correctly seated
onto the included wastebasket.
center of the feed slot.
away any dust or debris that has
collected on the sensor.
Shredder is Jammed or runs in "reverse" mode only

Reverse to remove paper
Pull up

Turn off shredder
Apply shredder oil and
wait for 30 min
30
Min

Turn on power
Use thick paper to push
jam through

Reduce sheets to
resume shredding
Shredder does not feed or shred credit card or small piece
of paper
Feed in the center
6-Sheet Micro-Cut Shredder
B00Q3KFX8U
!
Warning:
DO NOT USE ANY SPRAY
CANS OR AEROSOLS.
1) • Set the control switch to reverse.
• Pull the paper to remove jammed
paper (as much as possible).
2) • Turn off shredder.
• Apply shredder oil to the feed slot.
• Let oil soak in to paper and
machine for 30 minutes.
Note: 1. Repeat 1 & 2 steps if
needed
2. Shredder oil not
included.
3) • Set the power switch to turn on
shredder.
• Use thick paper stock or a
greeting card to push the jam
through.
4) • Reduce the number of sheets
being fed (count pages to be sure
not to exceed the maximum sheet
count).
• Refeed the paper.
• Position credit card or small piece of
paper over the credit card section of
the Feeder (center position).
• Try again.
EN