Cubicon Prime FW Update Manual

Cubicon Prime FW / SW Update Guide
■ Firmware

Firmware file extention will be changed after updating firmware from <.bin> to <.cur>.
If you need to update it again then the user needs to insert firmware file again to USB.

Download the firmware file according to steps below and update your 3D printer.
Click the link below and download the file.
1.
Download
-
Save the downloaded firmware files to USB provided.
2.
* Please unzip the ZIP file.
Put the USB into a 3D printer and power on the 3D printer with the switch.
3.
[Setting] → [EEPROM Set] → [Revert setting to factory defaults].
4.
■ Software
1. Click the link below and download the file.
Download (Mac ver.)
-
Download (Windows ver.)
-
2. Install downloaded Sofrware files on your PC.
3. Run the Cubicon Cura and set printer to 'Cubicon Prime – M22Z'.
4. Load any file with the following extensions. : .STL, .OBJ, .DAE, .AMF
5. Slicing and saving on USB.