Advertisement
Display
PV
＋
Switch off DTB
and re-power
it.
The model adopted in this example is: DTB4896RR with firmware V1.50.
1. Make sure RS-485 hardware communication cable in DTB has been connected to the computer.
2. Make sure the communication parameters in DTB are consistent with those in the computer.
Display
PV
Press
for
more than 3
seconds to enter
initial setting
mode
Press
continuously for
10 times
2007-09-17
SV
Status of the temperature controller
Press "down" key continuously until the value reaches 1357
(please DO NOT modify this value; otherwise system confusion
may
occur).
Press the two keys together once to return to main screen.
Main screen
Return to default value. The default sensor is PT100, which will be
displayed when DTB is not connected to a sensor or
thermocouple.
SV
Status of the temperature controller
Example displayed value
Example displayed value: PT100 Sensor
ON/OFF of communication write-in
- 8 -
Delta Temperature Controller User Manual
Explanations
Explanations
© DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
Advertisement
