MAXPEEDINGRODS Q92 Connection Manual

01 Rear camera input(Wi-Fi & Bluttooth® Singal enhance)
03 USB1 Charging
06 Power cmplifier
02 USB2 Charging
USB Cable
06 Power amplifier
RCA Input/Output
COMMON TROUBLESHOOTING GUIDE
Issues
No sound
Media not supported
Poor radio reception
Phone Link will Not Start
Bluetooth®
GPS
Backup camera
CABLE CONNECTION
08 01
05
04
07
01
Rear camera input(Wi-Fi & Bluttooth® Singal enhance)
Wi-Fi & Bluttooth® enhance cable
USB1 Charging
03
07 Wire harness connector
Cause
lnternal amplifier is off
Product is muted
External amplifiers
Audio source
External amplifiers
Media on USB flash drive
Radio area
Antenna
Bad Lightning R/USB cable
Locked device
Not charged
Phone Link Frozen
Bad signal
Not connecting to device
GPS Area
Do not support original camera
02 03 04
06
Protocol interface
Wire harness connector
Backcamera cable
USB Cable
Power cable
Go to Settings > Audio > Internal Amp ON
Touch the volume.
Check the external amplifiers are on.
Check the remote output wire has voltage.
Change the audio source.
Connect 12V ACC wire to the power amplifier wire.
Change the media format on the USB device.
Change the USB device.
Change the station.
Antenna output wire is not connected.
Connect Antenna to product.
Replace the cable.
Device needs to be unlocked.
Device needs to be powered ON for CarPlay/Android
Auto to function. Allow it to charge and power on.
Unplug the device, close all Apps and plug it inagain.
Connect back camera cable to enhance the signal,
We made two signal receive line with back camera.
Make sure the device is within range.
Device's Bluetooth connection needs to be turned ON.
Go to Setting > Connection > Power ON
Pair and Connect the device like new.
Place GPS under the windowshield.
Find a after market camera to connect.
07
02 USB2 Charging
05 Radio antenna jack
08 GPS
Radio antenna jack
05
Power cable
08 GPS
GPS Antenna
Solution