Dorman 13720 Manual

Use this Procedure for Vehicles without Drivers Information Center Buttons
To access this display, the vehicle must be in Park (P) with key in the ON position (as far as you
can go without cranking the engine)
1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING
ACTIVE will display.
3. Press and hold the lock and unlock buttons on the first keyless remote at the same time for
approximately 15 seconds . A chime will sound indicating that the remote is programmed.
4. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of
eight remotes programmed.
5. To exit programming mode turn key off and remove key. Test remote(s).