arpha D100 Programming Manual

Programming Guide
I. Operation process
1.1 Restore Factory Settings
Long press the reset button for 5 seconds, it will be reset to factory settings until a long "beep".
Note: It's a must to reset the lock before use.
1.2 Add code
A. If there is no administrator code, please short press reset key, enter your new administrator
code (6~8 digits) ended with button, then repeat the administrator code again and button.
A long "beep" and green light flashes. Then it's done.
Note: The first 3 passwords created are administrator codes by default.
B. If the administrator codes have been created, press the reset key, and two short "beep" will
prompt, verify the administrator password, then enter your code (6~8 digits) ended with
button, repeat the user password again and button. A long "beep" and green light flashes.
Then it's done.