OfficeMate 91966 Assembly Instructions

Hanging Folder Frame Assembly Instructions
(Stock #91966)
Figure A.
1
2
Frame is designed with one end for letter size
and one end for legal size hanging files.
Steel rail shipped as folded in figure A. To unfold, straight out 2 ends as figure B
Snap both rails for desired length to fit in drawers:
• place the rail on flat surface with indented snap line at the edge.
• hold the rail down with one hand, clamp pliers at snap line.
• bend the rail down, snapping off unwanted piece.
Long end for legal size
3
Choose the end for required size of hanging files,
placethe plastic joints on the frame ends as shown.
4
Insert rails into plastic receptacles as shown.
Asseble with caution! The edges may be sharp!
Assembly completed as shown.
Short end for letter size
5
X4
X2
X2
Figure B.
O cemate International Corporation
90 New eld Avenue
Edison, NJ 08837
Tel: (732) 225-7422
Toll Free USA Only: (800) 221-0400
Fax: (732) 225-6466
www.o cemate.com
Email: OIC@o cemate.com
Made in China
P/N: TS91997
04/2018