ALLSOP 30319 Setup Instructions

Lantern setup instructions
Step 1:
Attach the wire hanging handle by inserting the
curved ends of the handle into the raised tabs
located on the top of the plastic solar housing
compartment.
Step 2:
On the bottom side of the plastic solar housing
compartment, slide the power switch from the
OFF ON
"Off" position over to the "On" position. This
265mm
activates the AAA rechargeable battery that is
inside of the solar housing compartment.
Step 3:
Insert the circular end of the metal wire frame
197mm support around the Dual LED bulb. Pull the lan-
tern up to begin to form a globe shape.
OFF ON
Step 4:
Attach the "notched" ends of the wire frame
support into the wire rings located on the
bottom of the lantern.
Step 5:
Hang your lantern where it will receive direct
sunlight. Solar products will produce
optimum results when fully charged in direct
sunlight for between 6-8 hours each day.