Work Sharp WSEDCMCR User Manual

MICRO SHARPENER
N E W
& KNIFE TOOL
S H A R P E N
1
Place knife flat on the diamond sharpening guide at the
heel of the blade. Push the knife edge across the abrasive
using light pressure all the way to the tip. Repeat this
step using the opposing guide and pull the knife edge
across the abrasive. Alternate for 5-10 strokes per side.
PRO TIP
Sharpen on diamond rod until a burr is formed along the
entire length of the cutting edge.
H O N E
2
Switch to the ceramic. Follow the same steps as
above.
PRO TIP
Use only the ceramic hone for touching up a knife edge.
B I T D R I V E R
3
Bit Drivers can be used to tighten or loosen common
knife hardware such as pocket clips, frame fasteners,
thumb studs and pivots. Accepts any ¼" driver bits.
MORE PRO TIPS
Long knives may require multiple strokes in sections.
Use light pressure when sharpening and honing.
Serrations can be sharpened using the ceramic hone –
lay the flat side of the serrations on the ceramic rod
and use very light pressure to deburr.
F E AT U R E S
1
Fine Ceramic Rod
2 Medium Diamond Rod
3
T6, T8, T10 Bits
4
Lanyard
5
Bit Driver
USER GUIDE
1
4
1
1
2
3
3 2
5