DayClocks CL-P-E Setting Manual

Setting the Day-Only DayClock
Before starting, insert a AA battery.
Locate the two dials on the movement above the battery compartment.
Step 1
Gently pull out the smaller dial at the top center of
the movement. Turn the dial to rotate the day-hand
to the approximate time of the correct day.
Push the dial back in.
If the dial is not pushed all the way in, the hand
will not advance.
Step 2
Turn the large dial at the lower right of the
movement to make fine adjustments to the day
hand. For precision, we suggest calibrating the fine
adjustment at noon or midnight.
Troubleshooting Guide
Even a broken DayClock is right once a week...but let's fix this.
DayClocks typically run many years without fail. If a clock hand does not advance after a fresh battery has
been installed, please take the steps below. Any frustrations, don't hesitate to call us — we'll get your clock
ticking again.
1) If you put your ear next to the movement (the little black box where the battery goes) and you can hear it
ticking, check the small adjustment dial in the upper center of the movement. If the dial is not pushed in
all the way, the hand/s will not advance. Pull the dial out, then push it all the way in and twist a little until
it clicks.
2) If you put your ear next to the movement and do not hear ticking, contact us via phone or email and we'll
get your DayClock ticking again.
For additional assistance please contact DayClocks Customer Service:
info@dayclocks.com or 1-866-DAY-CLOC (329-2562).
DayTime, LLC dba DayClocks | www.dayclocks.com
18124 Wedge Parkway #448 Reno NV, 8951 1
Phone & Fax: (866) DAY-CLOC (329-2562)
Email: info@dayclocks.com