Dowco 50124-00 Installation Instructions

dowcopowersports.com – (800) 558-775
WARNING
In severely windy conditions, "ballooning" of the cover may occur, which may result in the wind causing the motorcycle to tip
over. It is strongly recommended that your motorcycle be sheltered whenever high winds are expected. If sheltering is not an
option, facing into gusts may reduce the potential for wind damage.
WARNING
This cover must be completely removed prior to starting or operating the vehicle. Failure to do so could result in serious injury
and/or property damage.
NOTE
This cover is not designed for covering your motorcycle while it is trailered or in the back of a pick-up truck.
1. INSTALLATION
▶ Unfold cover and remove Warranty Card
▶ Position the front of the cover on motorcycle. Starting in the front head light area, pull down over the windshield and tuck the
elastic hem under the head light. Working toward the rear of the motorcycle, slide the cover down the sides, avoiding snag
points. Position the cover around the rear of the motorcycle.
▶ Scure belly strap underneath the bike.
CAUTION
Mirrors, muffler ends, shifters, brakes and foot pegs are common wear points. Do not allow fabric to "snag" around
them. Antennas are capable of puncturing the cover – use extreme care.
2. CARE AND CLEANING
▶ Your cover requires very little maintenance. Normal dirt and grime should be brushed off with a soft terry cloth or removed with
warm water and a mild detergent using a sponge or terry cloth. The cover should be thoroughly dried before using.
CAUTION
Do not place in washing machine and do not wring or twist the cover to remove moisture. A water-repellent spray
material, such as 3M Scotchguard
inhibitors, the fabric may fade in direct sunlight after continuous use. This is normal wear.
INSTALLATION INSTRUCTIONS
PRODUCT: Weatherall Plus Motorcycle Cover
, is recommended for increased water resistance. Although protected with UV
®
141128-00 R8/15