Dowco Rally Pack Value Series Installation Instructions

WARNING
Please read and understand these instructions completely before installation to avoid possible injury to yourself or damage to
the accessory or vehicle. If you are unsure of your ability, seek the help of a qualified mechanic.
WARNING
Overloading any saddle bag will result in a high center of gravity, which will cause bike to become top heavy and susceptible to
unexpected tipping, especially on lean-in while negotiating high speed turns. Saddle bags must be loaded evely side-to-side
MAXIMUM ALLOWABLE LOAD LIMIT IS 7 LBS.

1. PREPARATION

▶ Tools required: none
▶ Place motorcycle on a secure & level surface

2. SADDLE BAG ASSEMBLY INSTALLATION

▶ Open saddlebag and remove contents.
▶ Locate bottom bag support.
Note: Support has velcro on bottom side that must match velcro in bag. It is not in the center.
▶ Bend support as shown. Plastic and velcro strip will be on the bottom. (Fig 1)
▶ Insert support into pocket inside the front of the bag. If support is all the way in pocket, velcro strips will match.
DO NOT attach velcro at this time.
▶ Insert support into rear pocket inside bag. It will be necessary to slightly bend support up to fit.
▶ Press velcro strips to mate. Smooth out any wrinkles.
▶ Determine location of exhaust pipe.
▶ A. If tail pipe is under tail section of bike - place silver side of protective heat shield to fender. Weave velcro straps from
saddlebags through webbing on black side of protective pad. Fasten.
▶ B. If tail pipe is on side of tail section - place silver side of protective heat shield toward saddle bag. This will protect fender from
any rubbing that may occur. Weave velcro straps from saddlebags through webbing on Silver side of protective pad. Fasten.
Fig 1
142291-00
INSTALLATION INSTRUCTIONS
BAG INSTALLATION: 50104-00, 50105-00
Value Series Saddle Bag and Tail Bag
INSTALLATION CONTINUED ON REVERSE SIDE
11/14