Father'sDen Collection FDGM-3501A Assembly Instructions & Care

ASSEMBLY INSTRUCTIONS & CARE
Table top Water Fountain with RBG LED Light
Model FDGM-3501A
The Water Fountain consists of 3 separate parts. Locate the (1) Water Feature (top).
(2) Water Holding Tray (base) (3) Water Pump &Adaptor cable with LED Light Bulb
STEP 1: Locate the Water connector plastic hose UNDER the Water Feature.
STEP 2: Gently ease the open end of the plastic hose onto the suction pipe on the pump
securely. Then Gently rotate the suction pipe, inside the hose, to Position the pump such
that the Power cable is nearest the exit slot at the back of the Water holding tray
STEP 3: Now insert the LED light bulb on the adaptor cable into the hole /slot provided under
the water Feature. Check Water Pump Flow Speed Switch on the side, is set to Maximum (+)
STEP 4: Place the Water Feature (Top) on top of the Water tray. As much as possible, secure
the pump to the bottom of the water tray with the suction pads on the pump base.
STEP 5: Carefully fill the feature with sufficient water (approx.500 to 700ml); taking care to
ensure the pump is fully under water.
STEP 6: Connect the pump and adaptor plug/transformer to a mains power outlet and
Use the ON/OFF switch along the length of the cable to power & run the assembled Water
Feature.
The adaptor plug/transformer & the On-Off Switch should never be submerged or stood in
water. Please note it is normal for the transformer to get warm while in use. If the
transformer gets too hot to touch, then there may be a fault. Please turn the unit off
immediately.
PUMP FLOW: The water flow can be adjusted with the regulator switch on the side of the
water pump. We recommend starting with the flow regulator fully open (on +) and then
adjusting it down if required.
ELECTRICAL SAFETY: This product is suitable for indoor use only.
Do not leave it running unattended. Keep this product out of the reach of children and pets
AFTER CARE INFORMATION
Water: We recommend that you use only Clean or Distilled water in this product..
Please avoid using hard water. Lime scale from hard water and other impurities tend to clog
up the water channels, which can damage the pump.
Cleaning Your Fountain:
A good weekly wash up should be sufficient to keep your Fountain going for a long time.
A swish with Vinegar or Lemon Juice helps to give a cleaner wash.
Top up the water regularly.
Always shut off the power before cleaning and maintaining the fountain or pump.
● To avoid danger of suffocation, keep the plastic bags away from babies and children.