Father'sDen Collection FDDS-2401 Assembly Instructions & Care

ASSEMBLY INSTRUCTIONS & CARE
Table top Water Fountain with RBG LED Light
Model FDDS-2401
The Water Fountain consists of 3 separate parts. Locate the:
(1) Water Feature (top}. (2) Water Container (base)
(3) Submersible Water Pump &Adaptor cable with single LED Light Bulb
STEP 1: Locate the Water connector plastic hose UNDER the Water Feature.
STEP 2: Gently ease the open end of the plastic hose onto the suction pipe on the pump
securely. Now gently turn the suction pipe inside the hose, to Position the pump such that
the Power cable exits the Water container through the slot at the flat back of the Water
Feature (top), without twisting the hose or cable.
STEP 3: Insert the LED light bulb on the adaptor cable into the hole /slot provided under the
water Feature. Set Water Pump Flow Speed Switch at its side to Maximum (+)
STEP 4: Place the Water Feature (Top) on top of the Water Container. As much as possible,
secure the pump to the bottom of the water container with the suction pads on the pump base.
STEP 5: Carefully fill the feature with sufficient water (approx.400 to 500ml); taking care to
ensure the pump is fully under water.
STEP 6: Connect the pump and adaptor plug/transformer to a mains power outlet.
Use the ON/OFF switch along the length of the cable to power & run the assembled Water
Feature.
The adaptor plug/transformer & the On-Off Switch should never be submerged or stood in
water. Please note it is normal for the transformer to get warm while in use. If the
transformer gets too hot to touch, then there may be a fault. Please turn the unit off
immediately.
PUMP FLOW: The water flow can be adjusted (from - to +) with the regulator switch that
can be found on the side of the pump. We recommend starting with the flow regulator fully
open (on +) and then adjusting it down if required.
ELECTRICAL SAFETY: This product is suitable for indoor use only.
Do not leave it running unattended. Keep this product out of the reach of children and pets
AFTER CARE INFORMATION
Water: We recommend that you use only Clean or Distilled water in this product..
Please avoid using hard water. Mineral build up from hard water or water from other sources
can damage the pump.
Cleaning Your Fountain
We recommend a weekly clean out if under constant use.
Top up the water regularly.
Always shut off the power before cleaning and maintaining the fountain or pump.
● To avoid danger of suffocation, keep all plastic bags away from babies and children.