DURASTEEL F-HA-404NK Assembly Instructions

Faucet
Assembly Instructions
Please make sure the size of the water inlet is 1/2" NPT female. If you
have any di erent type or size, we recommend you to nd a licensed
plumber to assist you with converting the inlet for installation.
Optional 90-Degree Elbows, please refer to below link.
1. Turn o water supply and ush lines.
2. Apply Te on tape or pipe joint compound to threads of male inlet(s).
*Te on tape must be applied by turning it clockwise around the thread.
3. Place male inlets through holes in backsplash.
4. Place washer and locknut onto male inlet on back side of backsplash.
5. Hand tighten locknut against backsplash.
6. Insert #2 spout into #1 faucet body. Using crescent wrench, tighten #3
spout nut onto threads of #1 faucet body.
7. Turn on water supply and check for leaks.
8. Remove aerator and ush lines for 1 to 2 minutes.
If you experience any assembly issue within 30 days of your purchase,
please take a short video of the issue, and send to (682) 626-6228 with your
order ID. You will require to follow our troubleshoot guideline, and answer
a few questions from the technician. Most of the issues can be resolved
during troubleshooting. If we believe the issue comes from manufacture,
we will send you replacement parts. Thank you!
Faucet 90-Degree Elbows (Sold Separately)
**Please use the link or use your phone camera to scan the QR code
to the right to purchase this item on Amazon.
Faucet 90-Degree Elbows
http://www.amazon.com/dp/B08JGSXZ18
This product contains chemicals known to the State of California to cause birth defects or other
reproductive harm. Lead, which is contained in all brass and bronze faucets, in very limited amounts,
appears on the state's list.
Contact Us
Our response will be in English
Purchase from
amzn.to/2Twy8Dk amzn.to/2PuT0
Note to users:
© 2021 DuraSteel All Rights Reserved
Locknut
Washer
Backsplash
1
amzn.to/2w7Cueb
Male Inlet
2
2
3
1