Universal Remote Control MRF100B POWERPACK Owner's Manual page 15

15
Learning Method
The RF20 can actually 'learn' commands from other remote
controls (old or new), one-button-at-a-time, so it will never
become obsolete. RF20 is the last remote you'll ever need!
Just follow these simple steps:
STEP 1:
Line-up the RF20 with the other
remote control, head-to-head,
one or two inches apart.
STEP 2:
On the RF20, press and hold
the MAIN and ENT (Enter)
buttons at the same time for
approximately three seconds,
until the word "SETUP" is
displayed at the top of the LCD
screen. This signals you are
now in SETUP mode.
IMPORTANT
You now have 30 seconds to perform
the next step while you are in SETUP
mode. If you don't press a button
within 30 seconds, SETUP will disap-
pear from the screen, signaling that
you have exited setup mode and you
will need to start over.
MAIN
BUTTON
ENTER
BUTTON
STEP 3:
Press the LEARN display button
on the LCD screen. The top of
the screen will change to
"LEARN" and display the five
Components from Page 1 of the
MAIN menu.
To display Page 2 of the MAIN
menu that lists an additional
five Components, simply press
the PAGE ( ) ( ) buttons.
STEP 4:
Select the Component you
want to teach commands to
by pressing that Component
display button on the LCD
screen (in this example, TV).
The top of the TV screen will
change to "TV".
NOTE: If you want to teach any command
to a Component button, press the
desired Component display button once
the top of the screen displays "MAIN", by
pressing the PAGE button.The top of the
screen wil change to "READY". Then go to
STEP 6.
LEARN
BUTTON
16