Quoizel MHE8409CU Assembly Instruction Sheet

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (2) B10 Candelabra Base bulbs 60W Maximum
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Fixture can only be mounted in the direction indicated on page 2.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Crossbar Assembly
A
x 1
Alternate
B Mounting Screw
x 2
Lock Screw
C
x 2
Fixture Loop
D
x 1
-
STEP 1 Install Fixture Loop
A. Thread Fixture Loop (D) onto the
nipple on the top of the Fixture
Body (E) and hand tighten until
snug.
STEP 2 - Fix the Flat Scroll in place
A. Rotate the Flat Scroll to the top of the ixture
end into the Fixture Loop ( ).
Flat Scroll
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2018 QuoizelInc.
Assembly Instruction Sheet #IS-MHE8409CU
for product cleaning tips. Go to the
20-30 minutes
Fixture Body
E
x 1
Cage
G
x 1
Figure 1
F Body (E) . Pull the scroll
D
D
E
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
For Style MHE8409CU
Care + Maintenance selection.
STEP 3 - Install Glass Panel
A. Insert Glass Panels (F) into the slot on the bottom of the Cage (G)
then fold the tabs in the top of the Cage (G) to secure Glass
Panels (F).
Glass
F Shade
x 4
Figure 3
D
STEP 4 - Install Cage with Glass Panels
A. Place slots side of the Cage (G) against the backplate. Align slots on
the top of Cage (G) to the studs inside of fixture hood and align holes
E
on the fixture hood to mounting holes on the Cage (G). Secure by
threading Lock Screw (C) into mounting holes. Hand tighten until
snug with screwdrivers.
Backplate
C
Mounting Hole
1of3
Slot
Stud
Hole
Slot
Figure 4
F
Tab
G
E
G
ReleasedDate:2018-01-25